South’s Drinking Water Crisis and Sustainable Solutions (2)

The experience of Saudi Arabia is particularly noteworthy in this regard. The country has long been using advanced desalination technologies to convert seawater into drinking water. In 2023, the Jubail 3A seawater desalination plant, built by a Chinese company in Saudi Arabia, became operational, with a daily production capacity of approximately 600,000 cubic metres. The project uses reverse osmosis (RO) technology alongside solar power. The solar power plant can meet around 20 per cent of the desalination plant’s daily electricity demand. This has demonstrated that even large-scale water treatment plants can reduce their dependence on conventional electricity by using renewable energy. The use of such technologies could be highly beneficial in Bangladesh. Solar power could meet a substantial portion, or even the entire electricity demand, of RO technology. The government could take initiatives to establish such plants at the national level with public funding. If necessary, assistance could be sought from donor countries such as China or other technologically advanced nations to facilitate the installation of RO systems.
Another important technology is electrodialysis (ED) and its advanced version, electrodialysis reversal (EDR). These methods use specialised ion-exchange membranes and an electric field to remove salt from water. Dissolved ions, including sodium and chloride, move towards oppositely charged membranes under the influence of the electric field. As a result, the salt concentration decreases in one stream, while salt-rich water is separated into another. Compared with RO technology, ED and EDR can be more effective and energy-efficient under certain conditions, particularly when treating water with low to moderate salinity. These technologies could be explored, especially in areas where groundwater salinity is lower than that of seawater. In areas relatively far from the Bay of Bengal but still experiencing salinity intrusion, the installation of ED or EDR systems could be considered. However, RO remains a more established and widely used solution for treating highly saline seawater.
Another method of treating saline water is thermal desalination. Notable technologies in this category include multi-stage flash distillation (MSF) and multi-effect distillation (MED). These methods involve heating saline water until it turns into steam. The steam is then cooled and condensed to collect fresh water. Although water evaporates, salt does not, allowing it to remain separated. In MSF technology, water passes through multiple chambers at different pressures and temperatures, producing steam in successive stages. In MED technology, the heat from steam generated in one stage is reused in the next, allowing heat to be recycled. These technologies have been used for many years in Saudi Arabia and other Middle Eastern countries. However, they require comparatively large amounts of thermal energy. Therefore, unless an affordable source of waste heat or excess industrial heat is available, the economic viability of these technologies should be assessed before adopting them for small and medium-sized water treatment projects in countries like Bangladesh.
In addition, solar-powered desalination, solar distillation and membrane distillation technologies also deserve consideration. Solar distillation uses the sun’s heat to evaporate saline water, which is then condensed to collect fresh water. The technology is relatively simple and reduces dependence on electricity. However, its water production rate is low, making it insufficient on its own to meet the needs of large populations. Membrane distillation uses temperature differences to drive water vapour through a hydrophobic membrane. This allows salt and most non-volatile substances to remain separated. The technology has potential if industrial waste heat or solar thermal energy can be used. However, its commercial application and costs still need to be assessed on a project-by-project basis.
Another point needs to be emphasised here. No single technology is suitable for all types of saline water. The salinity of seawater is different from that of groundwater or river water in coastal areas. In some places, the salt concentration is high, while in others it is relatively low. Moreover, water may contain arsenic, iron, organic pollutants or microorganisms alongside salinity. Therefore, before installing any technology, it is essential to test the water source and examine its total dissolved solids (TDS), electrical conductivity, ion concentrations, arsenic levels and microbial contamination in the relevant area. Installing equipment without first understanding the actual characteristics of the water may make it difficult to achieve the desired results.
Author: Researcher and Columnist
Email: ajoymondal325@yahoo.com












